Ahed Poultry Gutter is produced from PVC-based material with high UV resistance in Roof Applications, Mail Stream Solutions, it is used instead of zinc and similar materials in Roof, it ensures the controlled and healthy removal of rain water without damaging the roof substructure.

usage areas
PVC Winged gutter is produced from a PVC-based material with high UV resistance in mail creek solutions in roof applications and provides a controlled and healthy removal of rain water, which is used instead of zinc and similar materials on the roof, without damaging the roof sub-construction.

FEATURES
• Its application is practical and saves labor
• Stainless does not corrode
• Maintenance free and unaffected by outdoor conditions
• High resistance to ultraviolet and variable temperature differences thanks to reinforced additives.
• Thanks to its specially designed capillary grooves, it evacuates the rain water in a controlled manner and prevents possible rain water to pass under the tile due to the wind effect.
• Since it is produced in different colors, it provides an aesthetic appearance compatible with the coating.

Why Ahed PVC Fin Groove?
• Its application is practical and it saves labor.
• Does not rust, does not corrode.
• Maintenance Free and Unaffected by Outdoor Conditions.
• High Resistance to Ultraviolet and Variable Temperature Differences Thanks to Reinforced Additives.
• Thanks to its specially designed capillary grooves, it discharges rain water in a controlled manner, and prevents possible rain water from entering under the tile under the influence of wind.
• Since it is produced in different colors, it provides an aesthetic appearance compatible with the coating.

Application details
• AHED WING GUTTER IS PLACED ON THE VALLEY RIVER LINE IN A WAY TO COMBAT THE DRIVE SIDE.
• THE MATTERS TO BE CONSIDERED HERE IS THAT THE EXISTING RAIN DRIVE MUST TAKE THE SAME PAIN AS THE INSIDE CORNER ELEMENT AND IT MUST BE CAREFUL IF IT OVERFLOWS UP TO 3 CM.
• IT IS FIXED EVERY 40 CM ACROSS THE VALLEY DRIVE LINE WITH STAINLESS STEEL SHEETS, STARTING FROM THE SIDE BOARD.
• THIS PROCESS IS CONTINUED UNTIL THE ridge REGION IN THE TOP SECTION. IF ADDITIONAL REQUIREMENTS, AT LEAST 20 CM MUST BE MADE.
• THE COATING COVER MUST BE FIXED ON THE MAİL DREA, LEAVING A LITTLE OVERRIDE. IF POSSIBLE, THE COATING COVER MUST CUT THE EXCHANGE PROPERLY.