SEAT ADDITIONAL PRINCIPLES
If the vehicle has accessible seat anchors, the seat can be simply attached to the seat.
Its capacity is up to the maximum number of connections. A dismounted seat does not mean a seat removal.
The definition of accessible seat attachments is contained in Annex II Part C of MARTOY.
seat joints, welding, etc. If the seat is modified so that it cannot be reattached by permanent means, the seat
is considered removed.
In addition to the seat, the connections in all categories are included in Annex VII article 1.15 of this Regulation,
In addition, it is required to comply with article 1.19, article 1.31 in terms of seat belts. M2 and M3 categories
it must also comply with paragraph 1.50 of Annex VII. Removing the seat on the rails where the seats are attached
cutting, welding etc. no action is required.
How the connection or disassembly was made will be written on the report, connection detail pictures and assembly instructions will be written on the report.
will be added.
Seat made for M2-M3 category vehicles with a certificate of conformity before 13/02/2009
There is no need to seek compliance with the 2001/85/EC Directive in the modifications. Repair category
and/or class change, the compliance of its new category and/or class with all conditions.
must be documented or substantiated with an authorized technical service report.
The suitability of this modification should be reported by the authorized engineer.
1- Conversion of N Category Vehicles to M2-M3 Category by Modification
All items are searched.
2- Seat Modifications in M2-M3 Category Vehicles Produced After 13/02/2009:
a) AiTM 1.50 article requires other conditions except stability and overturning resistance.
b) If there is a seat or seat belt modification, the relevant article conditions of AITM are sought.
3- Class and/or category change in M2-M3 Category Vehicles registered before 13.02.2009
or in seat repairs
a) Annex VII- Article 1.50.1.1 (Load calculation) shall be sought.
b) Attachment tests will not be required, provided that an "E" or "e" approved seat belt is used.
c) In case of seat change or addition, provided that the seats are “E” or “e” approved.
connection details will be given in the project and its suitability will be checked, and also the seat connection test
will not be searched.